|
PITCH RAISING
Your piano is designed to sound its best when tuned to A-440
(A above middle C vibrates at 440 cycles per second), the international pitch
standard. At this pitch, power and tonal range are optimum and your piano will
match the pitch of other instruments. When your piano varies from A-440, pitch
adjustments are required to bring it back to standard. By always maintaining
your piano at standard pitch, you create long-term tuning stability because the
strings and structure stay in equilibrium. You also ensure proper ear training
because you always hear your music in the correct key. Why does a piano's pitch change? Piano strings change pitch for two primary reasons: the
initial stretching and settling of strings when the piano is new, and soundboard
movement due to humidity variation. In the case of new pianos, the pitch drops
quickly for the first couple of years as the new strings stretch and wood parts
settle. It's very important to maintain any new piano at the proper pitch during
this period, so the string tension and piano structure can reach a stable
equilibrium. (Most piano manufacturers recommend three to four tunings the first
year, and at least two per year after that.) If a piano has gone without tuning for an extended period,
its pitch may have dropped far below A- 440. This means that each of its
approximately 220 strings needs to be tightened considerably, adding tremendous
additional tension to the piano's structure. The problem is that as each string
is tightened, the additional load causes the pitch of previously adjusted
strings to change. Thus it is impossible to make a substantial change in pitch
and end up with a fine, accurate tuning in one step. Instead, a process called
"pitch raising" must first be done, in which all strings are raised to their
correct average tension levels. (Likewise, when a piano's pitch is higher than
standard, a pitch lowering procedure must be done to reduce string tensions to
approximately correct levels.) Only then can the piano be accurately tuned. In
other words, accurate tuning is only possible when all strings are so close to
their proper tension that only small further changes are needed during tuning.
These small changes then do not disturb the tuning of other strings. How far from standard pitch must a piano be before a pitch raise is necessary? Just when a pitch raise or lowering is necessary depends upon
how accurate the final tuning must be, and the size and quality of the piano.
Any net change in a piano's string tension during tuning will distort the final
result and reduce stability. Realistically, a pitch difference of a few percent
can usually be accommodated successfully during tuning. For average situations,
when a piano's pitch is noticeably different from that of other standard pitched
instruments, a pitch correction procedure is necessary before tuning. Whenever
exact pitch level is critical, such as in concert or recording instruments, any
pitch deviation must be corrected before tuning. How long does a pitch raise take? A pitch raise is essentially a special tuning procedure
designed to leave the piano approximately in tune. For moderate pitch
corrections the procedure takes about the same time as a tuning, or less.
Extreme pitch changes may require two separate pitch adjustments. |